These are the cutest little candy holders that you can make for stocking stuffers or table decorations! And they are easy to make, too! Check out the Christmas candy at the grocery store and see what you can find. I bought this box with these Christmas figures probably at Costco. I knew it might come in handy for “craft supplies”!
To make these, just cut a strip of cardstock at 2 1/2″ x 8 1/2″. Depending on your candy, you might need to vary that measurement but it worked fine for my little candies! Then score at 3 3/4″ and 4 3/4″, or just score 3 3/4″ from one end, turn the paper, and score at 3 3/4″ from the other end. That leaves space inside the treat holder about one inch wide to hold the candy. Instead of these candy figures, you could use a small cello bag of assorted candies and in that instance, maybe you need to make that inside space a bit wider.
If you want to make a window on the front, (Of course you do!!) just choose a punch or die that will fit your project. For mine, I used one of the Painted Labels Dies. You could also use a punch of some kind. Just make sure that your candy will show through the hole as you like. If you want to decorate with designer paper, as I did with the Sweetest Candy Designer Series Paper, cut that to fit on the treat holder front BEFORE you cut the hole in the cardstock. If you adhere the DSP first, then you don’t have to worry about matching the two openings.
It might be helpful to adhere a window sheet on the inside to keep the candy safe inside. You may have “official” Window Sheets in your stash or you may find a piece of scrap plastic around the house. I just cut it large enough to cover that window and applied Stampin’ Seal around the edges of the opening. I think the window sheet makes it look quite professional!
Put the candy inside, and to hold it in place, use a few Glue Dots but be very careful not to get any glue in contact with the chocolate. No one wants to eat a Glue dot! I stuck about two or three on the back of the candy figures, but you could also use one on the bottom of the figure.
Once the candy is in place, hold the top together and punch two holes for the ribbon with whatever punch you have. Use your favorite ribbon to tie it closed.
For the snowman treat holder, I added some die-cut snowflakes using the Snowman Dies. Since I had a scrap of White Glimmer Paper I used that for the snowflakes. When I spotted the tree in the die set I cut one out of a scrap of green cardstock I had and adhered that on the side of the snowman. You can decorate these little things however you like! You could add a small greeting or add some jewels or sequins for some bling!
Here are some Easter treats I made almost the same way.
These little Chocolate Christmas Candy Treat Holders are quick and easy to make and will make a fun gift or treat or decoration for everyone!