Tuesday the new Stampin’ Cut & Emboss Machine became available to customers so now it’s time to get familiar with the machine. Watch the video above to find out about the machine.
It’s easy to figure out the sandwich for each situation, unless the previous machine where I had to check my notes now and then to see what to use and in what order. These instructions are printed on the base platform and the plates are numbered. Note that he says in the video you don’t have to place the die in the center all the time.
Keep in mind that there are the regular, more flexible embossing folders and the 3D embossing folders that are stronger and don’t bend. The sandwiches are different for each.
I can’t wait to get my Magnetic Plate I ordered! It should be much better than the one we have had previously. There aren’t scattered magnets inside the platform which used to pull our dies off to the side sometimes. The whole piece is magnetic and it will be used as a cutting plate.
This should get you off to a good start with your new Stampin’ Cut & Emboss Machine!