What in the world is this blue thing, you might ask? It’s the new 3D Embossing Folder Plate! Well, what is that??
Because of the surprise change of Stampin’ Up! not carrying the Big Shot die-cutting machine anymore, they have also switched suppliers of dies and embossing folders. The new 3D embossing folders in the new catalog give that deep impression, even without spritzing with water, that our previous 3D Dynamic Embossing Folders did. However, with this new supplier, the folders are slightly thinner than the previous folders and therefore, you may have difficulty using them in your die-cutting machine.
You will probably have to experiment with your machine and see what works best. Do NOT FORCE anything through your machine. Maybe you need a tiny bit of extra pressure to get something to go, but if it doesn’t go, just stop! Try a different sandwich. Stampers are trying different sandwiches, maybe even with their original Big Shot platform with the tabs or with one of the mats or things we have been able to buy in the past.
Yesterday I made a sandwich with the Big Shot Platform, then the thin squishy mat. It’s the silicone mat and when it runs through the machine it squishes out at the end a little bit. Next, I placed my paper inside my Scripty 3D Embossing Folder and put a cutting pad on top of that (only one cutting pad in the whole sandwich). That worked fine! There may be other combinations but I haven’t had enough time to experiment. Some people are using the cardboard from Paper Pumpkin kits or maybe a piece or two of the cardboard in the designer paper packages would work.
OR if you don’t want to fool with all of that, this is what this blue 3D Embossing Folder Plate is for! Use this with the new folders and it should work fine. As another Demonstrator said, “It’s only $10 and it works.” I don’t own it yet so I can’t vouch for it yet.
The sandwich would be (on the bottom) the platform that comes with your machine, the embossing folder with cardstock inside, then the 3D Embossing Folder Plate. Stampin’ Up! says depending on your machine you may still need a shim ( thin piece or two of cardboard works).
Stampin’ Up! is still working on a new die-cutting machine for us, but there is no time frame that has been announced. I don’t know if we will use this blue plate in a new machine or not.
As you start receiving the new embossing folders, just keep these things in mind, that you will have to try and see what works best with your machine. But be careful, don’t force anything and break your machine. If you have it right, it will work and you don’t have to use brutal strength to get it to go!
You will find the new 3D Embossing Folder Plate in the Die-Cutting and Embossing Category of the Online Store and then under Embossing. Let me know if you have questions.