These Valentine’s Day Chocolate Candy Holders have been around a long time and I probably make them every year! I’ll link to some other ones I have made a little later. Once you have the pattern and the idea, you can run wild with decorating them for any occasion! Maybe party favors, or a little favor at a dinner party (when we can have dinner parties again!), or a stocking stuffer at Christmas, or a treat in an Easter basket! Whatever you want to make!

These Valentine’s Day Chocolate Candy Holders are just a strip of cardstock wide enough to hold your candy, with a slit inside to hold the candy if that works or space to place the candy and maybe secure with a tiny bit of adhesive. The cardstock is scored so that it will fold but have space for the chocolate. Put some adhesive on the inside of the bottom of the strip with the punched slit, and adhere. Then decorate the front and tie a ribbon around to secure.

Here are the particulars, if you are interested, for these projects.

Start with a strip of cardstock cut at 9 5/8″ x 2 3/4″. Score at 2 3/4″ and 3″; 6 1/4″ and 6 1/2″. With these measurements, you could get three strips out of one sheet of cardstock. Fold and crease on the scored lines. Open the strip back up and you will see above and below the score lines, one section is shorter than the other. You want the longer section to be the one that folds up to the inside.

Once you have identified the longer section, use the Classic Label Punch on that flap, inserting as far as you can, centered, to punch the opening for the chocolate. Put a piece of Tear & Tape at the bottom of the strip so you can fold up that flap and adhere to the inside, not quite up to the score line. You will want to stand the candy holder on the table making sure the bottom is flat as you adhere that flap.

The pink holder on the left is made with Blushing Bride Cardstock with a piece of the Love You Always Specialty Paper (2 1/2″ x 2 1/2″) adhered to the front of the candy holder. Then I simply layered two die-cut hearts popped up on Stampin’ Dimensionals so I could tie a ribbon (the Blushing Bride 3/8″ Metallic Ribbon) around to hold it closed. There are some other patterns more like a matchbook where you just slide the top into the little fold-up pocket at the bottom. But even then, you might like a ribbon to hold it all together.

The red candy holder on the right is made the same way. It has a piece of Basic White Cardstock on top, decorated with a stamped and die-cut heart from the Lots of Heart Stamp Set and Many Hearts Dies. (Get both in the Lots of Heart Bundle and save 10%!). The greeting is also in that stamp set and is punched out with the Classic Label Punch that you used on the inside for the slit to hold the candy. The heart is popped up on Dimensionals, again, to allow room for the ribbon to wrap around the candy holder.

If you would like more ideas, here are a couple of candy holders I made last year. These are so much fun to make, I know you will enjoy this project! They are perfect, of course, for Valentine’s Day, with a nice piece of chocolate on the inside! Try your hand at my Valentine’s Day Chocolate Candy Holders because they are quick and easy to make when the holiday is getting close!